ASSEMBLY AND SET-UP
Turntable Assembly
q Place the platter on the center spindle. The platter will adjust | DRIVER | |
itself to best fit over the spindle. |
| |
w Adjust the positioning of the platter so that the screw holes line | e | |
up perfectly. | r | |
e Screw and tighten accordingly. |
| |
r Place the slip mat on the platter. | w | |
*** Care should be taken to avoid dropping either/both, the | ||
| ||
platter or the cabinet. |
| |
| q |
• If the player is operated without fixing the screws, the platter may not rotate properly.
• Do not plug in to a power outlet until this unit is fully assembled and adjusted.
Installing the balance Weight
q From the backend of the tone arm (towards the rear panel) place the balance weight onto the shaft and turn counter clockwise. (Refer to the illustration)
Slip mat
q Place the slip mat on the platter. Then place a record on top of the slip mat. The slip mat is essentially used to give you better control over the spinning of your record. That is, with the slip mat in place you are able to stop, pull or push the record without affecting the rotation of the platter.
|
|
Top : Record disc side (Printed side)
Bottom : Slip surface side
(The slip mat included with this unit may differ from illustrations in this user guide or in other publications.)
5
