Vestax PDX-a1 manual FEATUREs, Safety Instructions

[FEATUREs)

• The PDX-a1 is a high end performance turntable

designed Ior the beginners and the professionals with the same basic quality as the beet selling turntable, the PDT-5000.

•FAST STARTS BY HIGH TORQUE

Using high-torque direct motor, the in&Dal motor’

delivers l&g-cm start torque. The high-torque gives quick starts that enables the platter to reach 33-H rpm within 0.5 second.

•FLOATING SUSPENSION TONEARM

The tonearm is mounted on the deck plate using a

floating suspension system with the drive moter. Acoustic feedback is minimised by this advanced system.

• QUARTZ-PHASE-LOCKED CONTROL

The pitch is variable continuously by up to approximately

f 10% and returned automatically to the predertermined speed (38-x or 45 rpm) by on/off switch even if the pitch control is employed.

e NON-CENTER-CLICK PITCH FADER

Pitch fader has no center click, and it allows delicate adjustment easily. The PDX-al features detachable pitch control fader for eatic of replacement when it is worn out.

#MJNI LIGIIT FOR ILLUMINATING STYLUS(OI?TIONAL) The PDX-al provids detachable small stylus illuminator

for illuminating the stylus tip during play for low-light

conditions.

•OTHER FEATURES

Quick stops are achieved with an electronic braking system.

Remote control jack is provided for controlling START/STOP by other equipment like a fader start etc.

[BEFoRE)

#CAUTION : Never connect the AC power plug before assembly has been completed.

•CHECKLIST OF PARTS :

This unit includes the f&wing par& ;

1. Turntable			Unit	6. Balance Weight
2.	Turntable		Platlor	7.45-rpm		Adaptor
3.	Slip	Mat		8.	RCA	Cable
4.	Shell	Weight		9.	GND	Cable
5.	Headshell

( SAFETY INSTRUCTIONS )

1.Avoid placement of the unit where it will be exposed to the direct sun light or where ventilation is inadequate.

2.Avoid places where there is water or humidity.

3.Don’t allow water or any foreign object to get incidc of thia unit.

4.Place this unit away from heatemitting appliances.

5.Place the unit on a stable, holizontal position, where there is little or no vibration.

6.Check the voltage rating of this unit before connecting the unil to a power supply.

7.fower supply cords should be routed so that they are not likely to be walked on or pinched by items placed on or against them, paying particular attention to cords at plugs. convenience receptacles, and the point where they exit from the aplliance. Never take hold of the plug or cord if your hand is wet, and always be sure to grasp the plug body when connecting or disconnecting.

8.Never attempt repairs yourself ;

A.The power supply cord or the plug has been damaged

B.iijeots have fallen or liquid has been spilled into the appliance

or

C.The appliance has been exposed to rain

D.&, appliance has been dropped or the enclosure damaged

E.Gie appliance does not appear to operate normally or exhibits a marked change in preformance.

9.Except for adjustments explained in the

operating instructions. do not attempt any repairs yourself. Be sure to request service from a qualified technician or your dealer or nearest service center,

-l-