Vestax PDX-a1 manual During the operation of above 2., if you want to

STYLUS ILLUMINATOR (Detachable Mini Light)

The small light for the stylus illumination is available as an optional extra.

REMOTE CONTROL

In cage you wieh to control the START/STOP with using external equipment like a foo~switch etc., input jack is provided at the left side of rear panel.

QUARTZ LOCKED CONTROL AND PITCH ADJUSTMENT

1.Whan the indicator lamp is lit ehowing the uporating condition tar the pi-e-determined spec.d (33-H Or 45 rpm).

Z.During the operation of m-e-determined speed, pitch control fader can not be functioned. And once press the quarts control button, the indicator lamp is put out, the speed can be adjusted by pitch control fader.

3.During the operation of above 2., if you want to

change the speed to the pre-determined one, press the quartz butlon. The indicator lamp lights and

speed will become pre-dotermined one even when

the pitch control fader not in the center.

4.Pitch control is poseiblo up to a maximum of

approximately rtlO%. Adjust the Pitch by sliding the Pitch Control Fader.

ACOUSTtC FEEOEACK AND HUM

Acoustic Feedback is uaally caused by vibration of speakers, which affects the ecnsitive cartridge. If such

a phenomenon occurs, relocate the turntable or speakers as far apart from each other as possible. Hum ie usually caused by nearby appliances that use

transformar or thermostat. Relocating the unit further away from the noise sources will readily solve the problem. Hum may also be produced if the

unit is not properly grounded. Make sure the grounding wire extending from the unit is securely

connected to the GND terminal on the amplifier or mixer.

INSTALLATION

Do not place the unit where it is exposed to direct sun

bght, high temperature or humidity to prevent pesslble troubles.

Place the unit in a stable and holizontal position, where there is little or no vibration.

Locate the unit as far away from the speakers as possible and isolate the unit’ from sound radiation from them.

rf the unit is placed too close to the radio, xnterference to AM/FM reception may result.

CONNECTION

COIUlect the output to inputs of amplifier or mixer. WHITE(t) .. ... ..I . .. .. m.L ChmnDl

RED(R) ..v. ... .. .. I,.. .. .R Chansl GND ..*... . ... . ... ..I. . ... ..GNl-j

Note Be sure to connect firmly-the GND terminal t,o the amplifier or mixer, or a power source HUM will result..

Relationship between Pitch and Fader Position

PITCH WY.-

-Ii-