OPERATION
LPlace the record on the turntable mat.
2.Prese the power switch button provided at rear panel to turn “ON” position.
%&move the stylus protector if cartridge is detachable one.
4.Puah the start/stop button, then platter will start to turn.
S.Move the tonearm position over the record. &Put it down to the record, and play wili begin. 7.Move the tonearm to the armrest when play is
finished.
&Push the start/stop button, and platter will stop.
Note : A manual method of operation has been chosen for the playing of records instead of using “Cue Levers” _
The unit has been set to select
automatically when the power button is pressed to on. Push the 45 rpm speed select button if you play 45 rpm record.
NOTES
I Before detaching or attaching the headshell, be sure to turn the power of the amplifier or mixer off.
0 Detaching or attaching of the headehcll with the volume control turned up may cause damage to the speakers.
a Do not turn “ON” the power supply, wi’ch the lurntable platter detached.
•When play is finished, be sure to secure the
tonearm with the arm clamp. Afler play is finished. if the unit ie not+to he IV& for aomu time, care should be taken to secure the tonearm to protect the stylus tip. For the same reason, the stylus protector should also be attached.
•Wipe the headshell terminals from time to time. Dust and dirt at the headshell terminals may result
in increased “HUM” noise or intermittent sound. Use a soft dry cloth to clean the headshell terminals.
•Dust and dirt should be carefully removed from stylus tip or records. Dust and dirt on the stylus tip or record may not only result in deterioration of tone quality, but alao cause undue wear of the record and the stylus tip itself.
•‘I’raneportatian of the unit to distant places for removal and the like. Pack up the unit in the
reverse order to that for unpacking, using the
packing materials furniehed when the unit was
purchased. Should there be no such packing materiala, be sure to take the foIlowing stepe.
Remove the turntable platter together with the turntable mat, and wrap it up to prevent any damage to them. Return the tonearm to the arm rest, and affix it with tape or the like. Remove the balance weight and the headshell/cartridge from the tonearm and then wrap them up, to
avoid and damage to them. Wrap up the turnrable base with a blanket or soft paper also to prevent any possible damage to it.
|
| SPECIFKATION |
TURNTABLE | MOTOR | DIRECT DRIVEQWARTZ |
| STARTING UP TIME | o.sR?c(33Wrpm)7v |
| STARTING TORQUE | 1.&g*cm |
| BRAKING SYSTEM | ELEmRONIC BRAKE |
| RAMBLE (S/N RATIO) 76dB(IEC98AWTD) | |
| SPEED | |
| PITCH | &lo% (DETOUCHABEE 1oonDnFADER) |
| wow | 0.03%W.R.M. 6. |
ARM TYPE EFFECTIVEWGTH OFFSmANGLE
OVERHANG TRACKING ERROR ANTI SKATING
1 STYLUS PRIBSUAE
1LIGHT(OPTKONAL,) SPEEDLOCK REMO'PE DYMENSION WEIGHT
POWER
STATICBALANCE SYSTEM
23omoJ;lmn
22'
16mn
1 DETOUCBABLE MINI LIGHT DCl2voltlOOmA
QUARTZ LOCK
MOMENTARY START (MINXJACK) ~W~460..X(N)15OnunX(D~370~ 9.5ap
AC117Vor230V
