Vestax PMC37Pro owner manual Program Section, 0C.F. Assign Switch, 1CUE Switch, 2INPUT Fader

PROGRAM SECTION

1	INPUT 2				INPUT 3
	PHONO 2	LINE 2		PHONO 3		LINE 3
			PGM 2
2	INPUT
	ASSIGN
		1
		2	3
				4
		GAIN			BAL
3
4	MIN		MAX		L	R
		ISOLATOR			ON
5					OFF
		LOW		MID	HI
6	+6dB					+6dB

-OOdB				-OOdB
	FILTER
	DRY		SWEEP
7
8	FILTER	MIN		MAX
	AUX 1		AUX 2
9
	PRE
	OFF
	POST
C.F. ASSIGN			CUE
A	B
10	MASTER		OFF	ON
11	PGM 2
	LEVEL
12

qINPUT SELECT SWITCH

Used to select input source from either PHONO or LINE.

wINPUT ASSIGN SWITCH

Used to assign the signal from each input, INPUT1 to INPUT4, to be sent to each PGM.

ePGM GAIN CONTROL

Adjusts the input level of each PGM. Set INPUT FADER (!2) to 7-8 position and adjust the GAIN CONTROL so that a sufficient signal is fed without distortion.

rPGM BALANCE CONTROL

Adjusts the stereo balance for each PGM. Can be used for adjusting an unbalanced stereo image. Clockwise rotation from center position increases

the volume of R over L channel. A counter clockwise rotation increases the volume of L channel over R.

tISOLATOR ON/OFF SWITCH

When set to "OFF", a full range signal is transmitted regardless of the position of any isolator controls.

yISOLATOR [HI/MID/LOW]

Cuts and boosts each frequency range. The level is flat when this knob is set at center (click point). Each frequency range can be boosted up to +6dB when this knob is pushed fully up. Pushing down will cut each frequency range.

uDRY-FILTER MIX FADER

Allows control of the signal balance between dry and effect (FILTER) sound. When the fader is located at center, each signal level is the same.

iSWEEP CONTROL

You can control peak point of band pass filter. When you rotate clockwise, the point is moved towards higher frequency. Rotating counter-clockwise moves point towards lower frequency.

oAUX ASSIGN SWITCH

This switch enables the signal from each program to be sent to EFFECT SEND JACK ($1). Different signal routes can be selected by moving this switch to the following different positions;

PRE: The signal before the input fader (after the EQ) will be sent to AUX output.

OFF: No signal will be sent to AUX output.

POST: The signal after the input and crossfader will be sent to AUX output.

!0C.F. ASSIGN SWITCH

Used to send the signal from each program to either side of the crossfader (A or B) or direct to the master. "A" for left side of the crossfader, "B" for right side.

!1CUE SWITCH

Used to send the signal from each program to the monitor section for headphone monitoring.

!2INPUT FADER

Used to adjust the Input level of each program. Usually set to 7-8 position. This is a detachable fader for ease of replacement, replace with IF- 37PCV when it is worn out. If you wish to use the fader unit with slide stroke distance of 45mm, you can replace with the Vestax "IF-05PCV". See "HOW

TO CHANGE THE FADER UNIT".

6