4. Installation
Electrical Connection
Please follow the instruction below to properly connect the LCD monitor to external electrical source.
1. Connect the female-end of the power cable to the transformer. Connect the male-end of the power cable to
the wall outlet or extension cable.
2. Connect the cable from the other end of the transformer to the LCD monitor DC IN located at the back of
the LCD monitor.
Signal Connection
1. Power off both the LCD monitor and PC system before connecting them.
2. Take out the VGA cable from the box and then connect it to the signal connector at the back of the LCD
monitor.
3. Connect the other end to the VGA connector on the back of the PC system.
4. Please make sure the connection to both the PC system unit and the LCD monitor are secure. Tighten the
screws on each connector end.
5. Now turn on both the PC system and the LCD monitor.
6. After you finish setting up the LCD monitor, please set the refresh rate to 75Hz.
7. After setting up the LCD monitor, please perform Auto Adjust in OSD so that the LCD monitor will be
automatically set to optimal display settings.
* Please note: When you disconnect any power cable or signal cable, please do not pull the cable by grabbing
the cable body. Please grab the cable connector itself whenever you try to pull the cable during
disconnect.
Page 11