ViewSonic PJD6345, PJD6544W warranty Wireless connection

4.Press to select the item you want to modify and press ENTER on the projector or Enter on the remote control.

5.Press / to move the cursor and the enter the value.

6.To save the settings, press ENTER on the projector or Enter on the remote control. If you do not want to save the settings, press MENU/EXIT on the projector

7.or Menu on the remote control.

8.Press to highlight Apply and press ENTER on the projector or Enter on the remote control.

Important

•If the RJ45 cables are not properly connected, the IP Address, Subnet Mask, Default Gateway, and DNS settings will display 0.0.0.0. Make sure the cables are properly connected and perform the procedures above again.

•If you wish to connect to the projector in its standby mode, be sure you have selected RJ45 and obtained the IP Address, Subnet Mask, Default Gateway, and DNS information when the projector is on.

Wireless connection

ViewSonic wireless dongle

P/N: WPD-100

To connect to the projector wirelessly, you have to plug a ViewSonic wireless dongle (optional) to the Type A USB connector on the projector, and then only a few OSD configuration steps are required.

1.Make sure the projector is turned on.

2.Press MENU/EXIT on the projector or Menu on the remote control and then go to Setting > LAN Control Setting menu.

3.Highlight Wireless LAN and press ENTER on the projector or Enter on the remote control.

4.Make sure the Status is Connect.

5.Make sure the SSID information is displayed.

6.In AP mode, you need to use your computer’s wireless connection utility to search the projector’s SSID and connect to it. The password of connection the Wi-Fi for the first time is “87654321”. Then you can search the projector with vsPresenter. To use Client mode, you should connect both your computer and projector to the same AP router and make connections with the IP address.

39