TECHNICAL SERVICE MANUAL
SERIES 855
Sizes AS, AK, AL, KE, KKE
SECTION
PAGE
ISSUE
TSM 685.2
1 of 16
C
CONTENTS |
|
Introduction | 1 |
Special Information | 3 |
Maintenance | 4 |
Parts Identification Drawings | |
Disassembly of Pump | 7 |
Disassembly of Coupling | 8 |
Disassembly / Assembly Bearing Carrier | |
Installation of Bushings | 10 |
Assembly of Pump | |
Pump Rotation | 11 |
Assembly of Couplings | 12 |
Adjusting End Clearance | 13 |
Pressure Relief Valve Instructions | |
Troubleshooting | 15 |
Warranty | 16 |
MODEL NUMBER CHART
UNMOUNTED PUMPS | UNITS | |
|
| |
Units are designated by the un- | ||
mounted pump model numbers | ||
| followed by the magnetic coupling | |
size and a letter indicating drive | ||
style. | ||
| (Example: | |
D = Direct Drive, Base Mounted | ||
| M = Motor, Face Mounted | |
B = Bearing Carrier | ||
R = Viking Reducer Drive | ||
| P = Commercial Reducer Drive | |
See Page 4 for complete description of | ||
| the model number | |
| table 1 |
WARNING!
Persons with surgical implants of a metallic or electronic nature should avoid working on pump – especially the inner magnet assem- bly.
This information must be read fully before beginning any maintenance or repair of the pump. All maintenance or repair must be done by SUITABLY TRAINED or qualified persons only.
INTRODUCTION
The illustrations used in this manual are for identification purposes only and cannot be used for ordering parts. Obtain a parts list from the factory or a Viking® representative. Always give the complete name of the part, part number and material with the model number and serial number of the pump when ordering repair parts. The unmounted pump or pump unit model number and serial number can be found on the nameplate secured to the pump.
This manual deals only with Series 855 magnetic drive pumps. Refer to Figures 1 through 22 for general configuration and nomenclature used in this manual. Pump specifications and recommendations are listed in Catalog Section 685.
In the Viking model number system, the basic size letters (AS, AK, AE etc.) are combined with the series number (855) indicating basic pump construction material.
FIGURE 1
SERIES AK855UB
Pump with Bearing Carrier
FIGURE 2
AK SERIES 855UB
Pump with Motor Directly Mounted to the Bracket
VIKING PUMP, INC. • A Unit of IDEX Corporation • Cedar Falls, IA 50613 USA