Viking F20670D manual Electrical Requirements General Information, Recommendations for Unpacking

Electrical Requirements

General Information

•	Oven requires a separate, grounded
	4-wire, 240V (AC), 30 amp (single ovens)
	and 50 amp (double ovens) service with
	its own circuit breaker.
•	Wire sizes and connections must conform
	with the rating of the appliance and to the

•	This unit is equipped with a No. 10
	ground wire in the conduit.
•	The electrical conduit must be kept to the
	top left for a flush installation. NEVER cut
	the conduit.

•All openings in the wall behind the appliance or in the floor under the appliance should be sealed.

•Keep appliance area clear and free from combustible materials, gasoline and other flammable vapors.

•Detach the product from the metal anchor strip by removing the attachment screw.

•DO NOT remove the protective wrapping from the product control panel until the product is installed.

	requirements of the National Electrical
	Code, ANSI/NFPA 70 – latest edition, or
	Canadian Electrical Code, CSA
	C22.1-1982 and C22.2 No. 01982 –
	latest edition, and all local codes and
	ordinances.
• Oven must be connected to the proper
	electrical voltage and frequency as
	specified on the model/serial rating plate
	(located inside the vent ont the right sode
	of the oven).
• Oven must be connected to grounded
	metal permanent wiring system. Check
	with a qualified electrician to make sure
	the oven is properly grounded.
•	DO NOT ground to a gas pipe.
•	DO NOT use an extension cord with this
	appliance, because this may result in
	electrical shock or other personal injury.

•	Connect the flexible armored cable
	directly to 4-wire, 240V household service.
	If codes permit and separate grounding
	wiring is used, we recommend that a
	qualified electrician determine the
	grounding path and that the wire gauge is
	in accordance with local codes.
•	Junction boxes installed on rear wall
	directly behind oven must be recessed .
•	A UL-Listed conduit connector must be
	provided at the junction box.
•	DO NOT install a fuse in the neutral or
	grounding circuit. We recommend a time-
	delayed fuse or circuit breaker. Connect
	directly to the fused disconnect (or circuit
	breaker box) through flexible armored, or
	non-metallic sheathed, copper cable (with
	grounding wire).

•Disconnect the electrical supply prior to servicing or cleaning.

•When removing the appliance for cleaning or service, disconnect AC power supply and carefully remove the appliance by pulling forward.

•Electrical requirements are listed in the product specifications under the electrical requirements section.

Recommendations for Unpacking

•Products are shipped on pallets with foam footings and corrugated inner-packing and exterior hoods.

•Products are anchored to the pallet using metal straps that are screwed to the bottom of the product and the pallet.

•DO NOT remove protective packaging until you are ready to perform the installation.

•To remove the packaging, first remove the staples located at the bottom perimeter of the corrugated cover.

•Remove the corrugated cover by lifting it off the product and remove the inner- packing.

Recommendations for Moving

CAUTION

The oven is heavy—use extreme care when handling.

WARNING

DO NOT use the handle or oven door to lift the oven. Remove door before installation to ensure that it is not used to lift the unit. DO NOT lift or carry the door by the handle.

•Only proper equipment should be used to move products.

•ALWAYS take steps to protect flooring at the installation location when moving products.

10 11