Viking F20875 EN Changing the Light Bulb, Clean the Touch Screen Display on the Dispenser Panel

Product Care

Cleaning (cont.)

Clean the Touch Screen Display on the Dispenser Panel

1.Make sure the refrigerator is unplugged or the power is disconnected before wiping the screen, to avoid unintentionally changing the settings.

2.Mix a solution of mild detergent in warm water. Dampen a soft, lint- free cloth with the solution and gently wipe the screen.

NOTE: DO NOT spray or wipe liquids directly onto the screen,or over-saturate the cloth.

3.Plug in refrigerator or reconnect power.

Clean the Exterior Surfaces

1.Unplug refrigerator or disconnect power.

2.Using a clean sponge or soft cloth and a mild detergent in warm water, wash, rinse and thoroughly dry stainless steel and painted metal exteriors.

•To keep your stainless steel refrigerator looking like new and to remove minor scuffs or marks, it is suggested that you use stainless steel cleaner and polish.

IMPORTANT: This cleaner is for stainless steel parts only.

DO NOT allow the stainless steel cleaner and polish to come into contact with any plastic parts such as the trim pieces, dispenser covers or door gaskets. If unintentional contact does occur, clean plastic part with a sponge and mild detergent in warm water. Dry thoroughly with a soft cloth.

3. Plug in refrigerator or reconnect power.

Clean the Condenser

There is no need for routine condenser cleaning in normal home operating environments. If the environment is particularly greasy or dusty, or there is significant pet traffic in the home, the condenser should be cleaned every 2 to 3 months to ensure maximum efficiency.

To clean the condenser:

1.Unplug refrigerator or disconnect power.

2.Remove the base grille.

3.Use a vacuum cleaner with a soft brush to clean the grille, the open areas behind the grille and the front surface area of the condenser.

4.Replace the base grille when finished.

5.Plug in refrigerator or reconnect power.

Changing the Light Bulb

NOTE: Not all appliance bulbs will fit your refrigerator. Be sure to replace the bulb with an appliance bulb of the same size, shape, and wattage (no greater than 40 watts).

•The dispenser lights and refrigerator compartment lights are LEDs that cannot be changed.

To Replace the Appliance Bulb in the Freezer:

1.Unplug refrigerator or disconnect power.

2.Remove the light shield(s), if necessary.

• Squeeze both sides of the light shield while pulling downward to remove.

3. Replace burned-out bulb(s) with appliance light bulb(s) no greater than

40 watts.

4.Replace the light shield(s) by inserting the tabs on the shield into the liner holes and snap into place.

NOTE: To avoid damaging the light shield, DO NOT force the shield beyond the locking point.

5.Plug in refrigerator or reconnect power.

Product Care

26 27