Operation
Convertible Display Shelves
Your wine cellar has two convertible display shelves - one in each of the top two compartments. To use the display shelf, first remove any wine bottles stored on the shelf. Next, remove the wine shelf directly above (see Shelf Removal section). Lift the shelf up, rotate the shelf support up and lock shelf into place with legs (see illustration below).
Shelf
Support
Wood Facings
Maple wood facings are included with each shelf. These facings may be left unfinished, finished and sealed, or replaced with other wood to match your cabinetry. Refer to the wine cellar installation instructions on how to replace the wood facings.
NOTE: Some finishes may cause undesirable odors. The recommended procedure is to test a sample in the wine cellar on scrap material before making permanent changes to wine cellar fronts.
Changing Light Tube (top zone)
To change the light tube, first remove the center grille assembly and turn the power ON/OFF switch to the OFF position (see the Before Using Your Wine Cellar section).
Control Panel
1.Remove the four screws from the lamp holder attaching the lamp holder to the underside of the control panel.
2.Rotate the rear of the lamp holder down and forward then pull the front tabs that engage into the control out of the control panel.
3.Set the lamp holder and screws to the side.
4.Pull the wires attached to the lamp tube through the hole in the control panel and disconnect the wires attaching the lamp to the cab inet wire harness.
5.The lamp tube is to be connected to one white wire and one yellow/red wire.
6.Place tubes in lamp holder. Feed wires back into control panel and reassemble in reverse order.
NOTE: Please contact your Viking Range Corporation parts distributor or dealer to order new light tubes.
Operation
16 | 17 |
