Front Panel
Power LED indicator
It is possible to operate the E 111 and E 112 equalizers while the LED remains lit. While the LED is OFF, the
signal fed to the | is delivered to the output connector or jack | ||||
as it is. |
|
|
|
|
|
Power switch |
|
|
|
|
|
Pushing this switch causes the power LED |
| to light and puts the equalizer in the operation mode. By | |||
again pushing the switch, the power LED | can be extinguished, permitting the input fed to the rear- | ||||
mounted input connector or jack | to be delivered to the output connector or jack | as it is. |
Tampering protection cover
Prevents accidental move of switch or control that has been set. Always fit the cover in place except when it needs to be removed for adjustment .
Rear Panel
E111
E 112
Fuse
Be sure to use the fuse of same type and capacity as are instructed.
Power inlet
An accessory power cord connects here. A use of the
Ground lift switch
The switch is used to avoid earth loop that causes hum noise when the equalizer (E 1ll/E 112) is connected to other equipment. By shifting the switch to the LIFT position, the earth loop may be cut. Normally, set the switch to NORM.
Output connector and phone jack
A balanced type connector and jack with output impedance of 600 ohms. Both are wired in parallel.
Input connector and phone jack
A balanced type connector and phone jack with input impedance of 10k ohms. Both are wired in parallel.
Power cord hangers
Wind the power cord onto the hangers when the equalizer (E 1ll/E 112) is not in use.
— 6 —