Villaware NDVLEM1000 Save these instructions, Extension Cord Use, Features, Special Cautions

Extension Cord Use

A short power-supply cord is provided to reduce the risk resulting from becoming entangled in or tripping over a longer cord. An extension cord may be used if care is exercised in its use. If an extension cord is used, the electrical rating of the cord must be at least as great as the electrical rating of the appliance. The extension cord should be arranged so that it will not drape over the countertop or tabletop where it can be pulled on by children or tripped over unintentionally.

Save these instructions

Features:

Warming	Brew Mode	Froth Mode	Water Reservoir
Zone	Button	Button	Lid

Special Cautions:

Caution: STEAM Pressure

In order to avoid possible burns to body parts and/or other injury from hot steam and water or damages to the unit, never remove the filter holder while your VillaWare® espresso/cappuccino maker is brewing coffee or frothing. The control knob should be in the OFF position before you can remove the filter holder to make additional cups of coffee.

CAUTION

Please follow these important safety instructions while using your unit:

1Before removing any of the parts and accessories as directed by this manual, make sure the control knob on the front of the unit is turned to the OFF position, press the center of the control knob for the OFF position and unplug the appliance.

2Do not remove the filter holder at any time during the brewing process. Scalding may result.

3Use caution when removing the filter holder. The metal parts may still be very

hot. Also, there may be hot water floating on the top of the filter. Hold it only by its handle and dispose the brewed coffee grounds by using the filter retention clip.

4If coffee does not drip from filter holder, it may be blocked. Turn off the appliance and allow it to cool down. The blockage may be caused by the coffee being too finely ground or tamped too tightly. See “Troubleshooting” on Page 11.

5WHEN CLEANING THE FROTHING TUBE: Place a frothing pitcher or large cup (with at least 11-ounce capacity) half full of water under the frothing tube cap. Make sure the tip of the frothing tube is submerged in liquid before turning the control knob to the Froth position. Froth the water for approximately 15 seconds, then wipe clean the frothing tube and cap.

NOTE: In order for your unit to work properly time after time, clean the frothing tip and tube after each use.

Center Power ON/OFF Button with Light Ring to indicate Power ON and Warming

Filter Holder

Removable Drip Tray & Grid

Frothing Tube

Single & Double Filters

Measuring Scoop/Tamper with wrench for removing tip

2 villaware.com villaware.com 3