Vinotemp VT-36 owner manual Installing Stainless Steel Handle

Installing Stainless Steel Handle:

•Pull away the door gasket in the area where the handle is to be installed. The gasket is easily removed by hand, no tools are necessary.

•Using a Flat head screwdriver remove the two (2) pre-installed decorative plugs from the backside of the door. Save the decorative plugs for future use.

•Insert the two (2) Phillips head screws with the lock washers and flat washers through the gasket side of the door frame until the screws pass through the door frame. Follow the sequence shown in the figure.

•Align the handle with the screws installed in the above step. Tighten the screws using a Phillips head screwdriver until the handles secure tightly against the door frame. (Do NOT over tighten as this will cause damage to the handle assembly).

•Replace the door gasket to its original position.

Gasket

Flat Washer

Lock Washer

Handle

Screw

Door Frame

1 7 6 3 1 S . S u s a n a R o a d , R a n c h o D o m i n g u e z , C A 9 0 2 2 1	11
info@vinotemp.com