Vision Fitness ST200 manual Blue BAG

2a	2c
	2d
2b	2e

2f

1b

STEP 2 BLUE BAG

•Thread pull pins partially onto 2a (Qty. 1) and 2c (Qty. 2).

•Lay the front center vertical (2f) on the floor. Slide the seat support structure (2a) over the open end of 2f. NOTE: You must pull the pull pin out (2b) and hold it when sliding over 2f. Release and engage the pull pin in one of the lower holes of 2f.

•Slide the seatback support structure (2c) over the open end of 2f. NOTE: You must pull the pull pin (2d) out and hold, while sliding over 2f. Release and engage the pull pin in one of the upper holes of 2f.

•Attach the exercise card post (2e) to the appropriate holes of 2f with two spring (SW6.1x12.2x1.5T) and flat (6.4x14x1T) washers, and two bolts (M6x1Px15L). Tighten the bolts using a 4mm L-shaped wrench.

•Place 2f on top of 1b. Slip a flat (10.5x18x2T) washer over each bolt (M10x1.5Px60L) and slide through the left side. Attach a flat (10.5x18x2T) washer and a nut (M10x1.5P) to each bolt on the right side. Tighten using a 6mm L-shaped wrench and a 17mm wrench.

10