Vision Fitness ST250 manual Weight Plates

STEP 1 WEIGHT PLATES

5b

5a

5c

5e

•If you aren’t adding any weight plates to the stack, skip this step and proceed to Step 2.

•Your unit is equipped to handle

21-ten pound plates (20 plates and the header plate). If you are adding plates to the stack after it has been in use, proceed as follows: Loosen the nuts, attached to the bolts (5g) with a 10mm wrench and a 4mm L-shaped wrench, and remove. Allow the guide rods (5c) to drop to the bottom of the tube (1b). With the weight selector pin disengaged, raise the header plate assembly (5e) and each successive weight plate (5d) over the top of the guide rods. Remove the steel tube spacer (5a).

•Before stacking the 20 weight plates back on, place rubber bumpers (5b) directly above each hole of 1b. Make sure you slide the weight plates with no decals on first. Slide the header plate assembly onto the top weight plate. Reattach the washers and nuts to the bolts to the appropriate holes (5g) of the guide rods. Attach the appropriate decals to the weight plates.

1b 5g

5d

8