STEP 7 BLACK BAG

Begin routing cable #6 with the end opposite the steel ball end. Feed the cable over pulley R, under S, around T, and under U. Unscrew the nut from the slotted bolt (M12). With the threads of the bolt facing up, slide cable #6 through it and reattach the nut. Thread the bolt into the post of pulley V, just enough so the cable won’t fall out. Slip the opposite end of the cable (ball end fitting) through the wide opening, on the side of the U bracket. Place the U bracket over the cable receptor attachment point on the main floor support (1b). Line up the holes and slide the shoulder bolt (15x33L) through the 3 holes. Attach a spring (SW10.2x18.4x2.5T) and flat (10.5x18x2T) washer and nut (M10x1.5P) using a 6mm L-shaped wrench and a 17mm wrench. Tighten until the end of the bolt protrudes beyond the end of the nut. Do not crush the U bracket.

WARNING: FAILURE TO PROPERLY COMPLETE THIS STEP COULD RESULT IN SERIOUS INJURY!

Go back up and tighten the slotted bolt (M12), until the cable is taught (a minimum of 0.5”). Tighten both the bolt and the locking nut using a 19mm wrench.

NOTE: With the weight selector pin engaged in the 10 pound hole, pull on all three cable ends. There should be no more than 0.5” of play in the cable. This means that the 10 pound weight should begin to move vertically, within 0.5” of cable pull. If there is more distance than this, tighten the appropriate bolts until you achieve 0.5” or less. If you over tighten, the weight selector pin won’t fit easily in the rod that accommodates the weight stack.

V

R

S

Cable #6

T

 

 

U

Ball End

Fitting

14

Page 14
Image 14
Vision Fitness ST250 manual Ball End Fitting