
S T E P 1 | ORANGE BAG |
| • Slide the rubber covers on to the left |
| & right console supports, making sure |
| that the lower cutout is facing inward. |
| T9700: Slide the data cable down the |
| right console support using the white |
| wire tie as a guide. Make sure that |
| the data (1 large ribbon cable) goes |
| through the large hole in the lower |
| part of the console upright. |
| T9200, T9500, T9600: Slide the data |
| cables down the right console support |
| using the white wire tie as a guide. |
| Make sure that the data cables (one |
| small & one large |
| cable) go through the large hole in the |
| lower part of the console upright. |
| • Insert the left console support into |
S T E P 1 | the console support bracket and |
secure with two bolts (M8 x 55L | |
| Flathead) in the side of the console |
| support bracket. |
| • Insert one bolt (M8 x 20L) in the |
| rear of the console support bracket. |
| • Tighten all three bolts with the 5mm |
| Allen wrench. |
| • Repeat this on the right side. |
| NOTE: There are no data cables on |
| the left side. |
5