Visonik MCT-441 specifications Preparation for USE, Miscellaneous Comments, Español, Introducción

If the MCT-441 was enrolled to PowerMax or PowerMax+ revision

2.9and down, you have to cause the detector not to send AC failure messages, as follows:

Continuously press the Test/Silent button for 10 seconds approximately, until a long beep (2 seconds) is heard. This beep indicates that the detector will not to send AC failure messages. To return to AC failure reporting capability, repeat the above action.

4. PREPARATION FOR USE

4.1 The LED Functions

Once the unit is plugged into the wall outlet, the green power indicator flashes indicating that power is present and the unit is working. After an initial ten minute warm-up period, the unit will start the process of continually sampling the air around it.

Table 1. LED functions

LED	Function
Green	Flashing: During the first ten minutes (after power
	connection) the green LED flashes (stabilization time).
	Constant light: The equipment is ready for operation: "Power ON".
Orange	Illuminates in the event of trouble and emits a lengthy buzzer sound.
Red	Flashes and a supplementary acoustic signal generator
(alarm)	(transducer) sounds intermittently in the event of an alarm.

4.2 Test Button and Muting Switch

Press down on the Test / Silent button (see Figure 2) to test the operation of the indicators. The red and orange LEDs will flash and an acoustic signal tone will sound intermittently. This action should be performed once a week. Use the Test / Silent button (see Figure 2) to switch off the acoustic alarm tone in the event of an alarm. The red LED will continue to flash and a short signal tone will sound approximately every 45 seconds.

Note: Do not test the MCT-441 using a gas lighter.

Note: In the event of a gas leakage, the smell of the gas may be in the air before the detector activates the alarm.

5. MISCELLANEOUS COMMENTS

Visonic Ltd. wireless systems are very reliable and are tested to high standards. However, due to low transmitting power and limited range (required by FCC and other regulatory authorities), there are some limitations to be considered:

A.Receivers may be blocked by radio signals occurring on or near their operating frequencies, regardless of the digital code used.

B.A receiver responds only to one transmitted signal at a time.

C.Wireless devices should be tested regularly to determine whether there are sources of interference and to protect against faults.

D.It is recommended to unplug the detector from the electricity mains before cleaning. Clean only using a dry cloth. Do not clean using a liquid substance. Clean externally only.

The user is cautioned that changes or modifications to the unit, not expressly approved by Visonic Ltd., could void the user’s FCC or other authority to operate the equipment.

W.E.E.E. Product Recycling Declaration

For information regarding the recycling of this product you must contact the company from which you orignially purchased it. If you are discarding this product and not returning it for repair then you must ensure that it is returned as identified by your supplier. This product is not to be thrown away with everyday waste.

Directive 2002/96/EC Waste Electrical and Electronic Equipment.

The technical documentation as required by the European Conformity Assessment procedure is kept at:

UNIT 6 MADINGLEY COURT CHIPPENHAM DRIVE KINGSTON MILTON KEYNES MK10 0BZ. Telephone number: 0870 7300800, Fax number: 0870 7300801

WARRANTY

Visonic Limited (the “Manufacturer") warrants this product only (the "Product") to the original purchaser only	However, if the Manufacturer is held liable, whether directly or indirectly, for any loss or damage arising
(the “Purchaser”) against defective workmanship and materials under normal use of the Product for a	under this limited warranty, THE MANUFACTURER'S MAXIMUM LIABILITY (IF ANY) SHALL NOT IN
period of twelve (12) months from the date of shipment by the Manufacturer.	ANY CASE EXCEED THE PURCHASE PRICE OF THE PRODUCT, which shall be fixed as liquidated
This Warranty is absolutely conditional upon the Product having been properly installed, maintained and	damages and not as a penalty, and shall be the complete and exclusive remedy against the Manufacturer.
operated under conditions of normal use in accordance with the Manufacturers recommended installation	When accepting the delivery of the Product, the Purchaser agrees to the said conditions of sale and
and operation instructions. Products which have become defective for any other reason, according to the	warranty and he recognizes having been informed of.
Manufacturers discretion, such as improper installation, failure to follow recommended installation and	Some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, so these
operational instructions, neglect, willful damage, misuse or vandalism, accidental damage, alteration or	limitations may not apply under certain circumstances.
tampering, or repair by anyone other than the manufacturer, are not covered by this Warranty.	The Manufacturer shall be under no liability whatsoever arising out of the corruption and/or malfunctioning
The Manufacturer does not represent that this Product may not be compromised and/or circumvented or	of any telecommunication or electronic equipment or any programs.
that the Product will prevent any death and/or personal injury and/or damage to property resulting from	The Manufacturers obligations under this Warranty are limited solely to repair and/or replace at the
burglary, robbery, fire or otherwise, or that the Product will in all cases provide adequate warning or	Manufacturer’s discretion any Product or part thereof that may prove defective. Any repair and/or
protection. The Product, properly installed and maintained, only reduces the risk of such events without	replacement shall not extend the original Warranty period. The Manufacturer shall not be responsible for
warning and it is not a guarantee or insurance that such events will not occur.	dismantling and/or reinstallation costs. To exercise this Warranty the Product must be returned to the
THIS WARRANTY IS EXCLUSIVE AND EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES,	Manufacturer freight pre-paid and insured. All freight and insurance costs are the responsibility of the
OBLIGATIONS OR LIABILITIES, WHETHER WRITTEN, ORAL, EXPRESS OR IMPLIED, INCLUDING	Purchaser and are not included in this Warranty.
ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, OR	This warranty shall not be modified, varied or extended, and the Manufacturer does not authorize any
OTHERWISE. IN NO CASE SHALL THE MANUFACTURER BE LIABLE TO ANYONE FOR ANY	person to act on its behalf in the modification, variation or extension of this warranty. This warranty shall
CONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREACH OF THIS WARRANTY OR ANY OTHER	apply to the Product only. All products, accessories or attachments of others used in conjunction with the
WARRANTIES WHATSOEVER, AS AFORESAID.	Product, including batteries, shall be covered solely by their own warranty, if any. The Manufacturer shall
THE MANUFACTURER SHALL IN NO EVENT BE LIABLE FOR ANY SPECIAL, INDIRECT,	not be liable for any damage or loss whatsoever, whether directly, indirectly, incidentally, consequentially or
INCIDENTAL, CONSEQUENTIAL OR PUNITIVE DAMAGES OR FOR LOSS, DAMAGE, OR EXPENSE,	otherwise, caused by the malfunction of the Product due to products, accessories, or attachments of
	others, including batteries, used in conjunction with the Products. This Warranty is exclusive to the original
INCLUDING LOSS OF USE, PROFITS, REVENUE, OR GOODWILL, DIRECTLY OR INDIRECTLY
	Purchaser and is not assignable.
ARISING FROM PURCHASER’S USE OR INABILITY TO USE THE PRODUCT, OR FOR LOSS OR
	This Warranty is in addition to and does not affect your legal rights. Any provision in this warranty which is
DESTRUCTION OF OTHER PROPERTY OR FROM ANY OTHER CAUSE, EVEN IF MANUFACTURER
	contrary to the Law in the state or country were the Product is supplied shall not apply.
HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.	Warning: The user must follow the Manufacturer’s installation and operational instructions including testing
THE MANUFACTURER SHALL HAVE NO LIABILITY FOR ANY DEATH, PERSONAL AND/OR BODILY	the Product and its whole system at least once a week and to take all necessary precautions for his/her
INJURY AND/OR DAMAGE TO PROPERTY OR OTHER LOSS WHETHER DIRECT, INDIRECT,	safety and the protection of his/her property.
INCIDENTAL, CONSEQUENTIAL OR OTHERWISE, BASED ON A CLAIM THAT THE PRODUCT FAILED
	1/08
TO FUNCTION.

ESPAÑOL

1. INTRODUCCIÓN

MCT-441 es un detector de gas completamente supervisado muy facil de instalar, el cual protege espacios interiores.

El MCT-441 es un detector de gas natural diseñado para enviar alarmas al detectar gas Metano. Estos detectores pueden usarse en apartamentos, caravanas, barcos o yates.

Los detectores se alimentan con la red, con 220 VAC. Una pila interna de Litio sirve para informar de un fallo de corriente sólo (no alimenta el detector).

El detector puede enviar los siguientes mensajes al panel de control del sistema de: Alarma de Gas, fallo del sensor de gas, fallo de corriente y batería baja.

MCT-441 están diseñados para su montaje en pared y deberían colocarse en un lugar donde haya presencia de gas, por ejemplo donde pueda haber fugas.

En caso de detección, emite un zumbido y el transmisor integrado transmite un mensaje digital, compuesto del PowerCode ID del

detector seguido de mensajes de estado. Las alarmas y otros datos son, por tanto, remitidos al sistema de alarma. Un mensaje periódico de supervisión se transmite automáticamente (ver especificaciones) para informar al sistema de alarma de la participación activa de la unidad en el sistema.

Los detectores de gas MCT-441 tienen un código ID de 24 bits, seleccionado aleatoriamente desde fábrica de entre más de 16 millones de combinaciones posibles. Este código es, por tanto, único y virtualmente imposible de reproducir.

Los receptores PowerCode compatibles se diseñan para “aprender” los específicos y responder solamente a ellos.

2. ESPECIFICACIONES

Compatibilidad: Compatible con toda la familia de productos del sistema de alarma PowerMax (PowerMax / PowerMax+ / PowerMax Pro / PowerMaxComplete), receptor MCR-304, receptor MCR-308 o cualquier otro sistema de alarma PowerCode.

Tipo de Gas: Metano (CH4).

Frecuencia (MHz): 433.92, 868.95, 869.2125 u otras frecuencias acorde a requerimientos.

Código ID del Transmisor: código digital de 24 bits, con más de 16 millones de combinaciones, modulación de anchura de pulso.

Longitud completa del mensaje: 36 bits.

Volumen de la señal audible: Al menos 85dB a 3 m de distancia.

Onda de respuesta: 8% ± 3% del Límite Inferior de Explosión (LEL) del gas.

Supervisión: Señalización en intervalos de 15 minutos, o acorde a estándares locales.

2 D-300707