VIVOTEK - A Leading Provider of Multimedia Communication Solutions
6 - User's Manual

Hardware Reset

There is an indented reset button on the back panel of the Network Camera� It is used to reboot
the Network Camera or restore the Network Camera to factory default� Sometimes rebooting the
Network Camera could set the Network Camera back to normal state � If the problems remain
after rebooted, restore the Network Camera to factory default and install again�
Reboot: Press and release the indented reset button once with a needle� The status LED will
blink in red�
Restore: Press the indented reset button with a needle continuously for over ve seconds. The
status LED will blink in red� Note that all settings will be restored to factory default�
Installation

Hardware installation

Follow the steps below to mount the lens to the Network Camera:
1� Mount the lens by turning it clockwise onto the camera mount until it stops� If necessary, turn
the lens counterclockwise slowly until it gets the best attitude�
2� Connect the lens cable plug to the camera connector�
1
2