VIZIO JV50P HDTV10A User Manual
Version 5/21/2007 27
www.VIZIO.com
2.8.1 Pairing Procedure 1. Turn on the HDTV using the remote control.
2. Press the MENU button on the remote to activate the
On Screen Display (OSD) which will display the
Picture menu.
3. Press the button once and then press the OK
button to change to the Audio menu.
4. Make sure the Speakers and Wireless Speakers
selections are both On. If not, use the and
buttons to correctly set them to On. (See Chapter 4 on
how to navigate the OSD.)
5. Place the sub-woofer 10 ~ 12 feet away from the TV, preferably with the front, (the side with
the large round hole near the top), facing the TV screen.
6. Turn-off the HDTV.
7. Plug the sub-woofer power cable into a wall socket and it will power on automatically and the
power indicator light on the front will start flashing on and off*.
8. Press the CH-SEARCH, PAIRING button and while keeping is depressed turn on the HDTV
using the remote.
9. When the power indicator light on the front of the sub-woofer stops flashing and remains on
you have successfully paired the sub-woofer with the HDTV and you can release the button.
If the sub-woofer power indicator light does not remain on then the Pairing Procedure was not
successful and you must repeat steps 1 ~ 9.
* When the HDTV is off the sub-woofer power indicator
light will flash on and off at a slower rate to indicate
that it is in Standby mode.
NOTE: If the wireless speaker system receives
interference from other equipment you can try
correcting it by turning the HDTV off and on so the
wireless system will automatically scan for a clear
wireless channel. If this does not work you must locate
the offending equipment turn it off or change the
wireless channel it is using.