Vizio JV50P Chapter 3 Setting Up to Watch Television

VIZIO JV50P HDTV10A User Manual
Version 5/21/2007 30
www.VIZIO.com
Chapter 3 Setting Up to Watch Television
For ‘Preparing Your Plasma HDTV for Wall Mounting’, see page 5.
3.1 Basic Plasma HDTV Start Up
1. Connecting the Power Cable
Connect the power cord to the power cord connector on the back of the HDTV, and then plug the
power cord into an AC wall socket.
2. Connect Audio and Video Cables to the HDTV
(see pages 15 ~ 25 for detailed steps)
3. Turning Power On
Once all the components are connected, press the
Power ON button on the side of the HDTV, or press
the Power ON (Red) button on the remote control.
4. Select Input Source
Select the Input Source for the HDTV by pressing the
INPUT button on the side of the TV or using the Input
button on the remote control. Pressing this button will
cycle you through the following options: TV, AV1, AV2,
Component1, Component2, RGB, HDMI1, HDMI2,
HDMI3 and AUX IN.
5. Using DTV and TV with an Antenna or Cable
At first power on, the HDTV will have the DTV/TV input
selected and will guide through some setup screens.
If it is not the first time the HDTV has been powered on,
you will need to select TV using the INPUT button on
the remote control or the side of the HDTV, or directly
by pressing the TV button on the remote control, and
Auto Scan for the available TV channels.
a. The screen will show ‘snow’ and
the first Initial Setup OSD panel.
Press the OK button on the
remote control.
Note: If you do not see this option within the OSD, you might
have selected the wrong input in the previous steps and you will
need to repeat step 4 (above) to select the correct input source.