VIZIO VP42 HDTV20A User Manual
Chapter 3 Setting Up to Watch Television
For ‘Preparing Your Plasma HDTV for Wall Mounting’, see page 5.
3.1 Basic Plasma HDTV Start Up
1.Connecting the Power Cable
Connect the power cord to the power cord connector on the back of the HDTV, and then plug the power cord into an AC wall socket.
2.Connect Audio and Video Cables to the HDTV (see pages 13 ~ 25 for detailed steps)
3.Turning Power On
Once all the components are connected, press the Power ON button on the side of the HDTV, or press the Power ON button on the remote control.
4.Select Input Source
Select the Input Source for the HDTV by pressing the INPUT button on the side of the TV or using the Input button on the remote control. Pressing this button will cycle you through the following options: TV, AV1, AV2, Component1, Component2, RGB, HDMI1 and HDMI2.
5.Using DTV and TV with an Antenna or Cable
At first power on, the HDTV will have the DTV/TV input selected and will guide through some setup screens. If it is not the first time the HDTV has been powered on, you will need to select TV using the INPUT button on the remote control or the side of the HDTV, or directly by pressing the TV button on the remote control, and Auto Scan for the available TV channels.
Note: If you do not see this option within the OSD, you might have selected the wrong input in the previous steps and you will need to repeat step 4 (above) to select the correct input source.
a.The screen will show ‘snow’ and the first Initial Setup OSD panel.
Press the OK button on the remote control.
Version 4/20/2007 | 26 |
| www.VIZIO.com |
