Vizualogic 2003 owner manual Care and Maintenance, Troubleshooting

Care and Maintenance

Your Vizualogic® System is a product of superior design and craftsmanship and should be treated with care. The suggestions below will help to fulfill any warranty obligations and provide many years of enjoyment.

•Cleaning the Monitor Screen and Housing: The components may be cleaned by occasional gentle wiping with a soft, lint-free, cotton cloth that has been slightly dampened with water.

CAUTION: Do not use liquids, abrasives, aerosol cleaners, or paper cleaning products because they will result in permanent damage to the finish of your components! The LCD screen is made of a specially coated glass and can be scratched or damaged by abrasive or ammonia-based window cleaners.

•Use and Storage:

-These units contain precision electronics that must be protected from dust, dirt, and moisture.

-Never spill liquids on any of the components. Liquids, humidity, and precipitation contain minerals that will corrode electronic circuits.

•Take care to avoid the following:

-Rough handling can break internal circuit boards. Do not drop, knock, or shake the components.

-Do not attempt to paint or refinish the components. Paint can clog moving parts and prevent proper operation.

-The components can be damaged by non-expert handling. Attempting to open any of the components may void the limited warranty.

Troubleshooting

•No Display: (Screen is blank)

-Point remote control at screen and press “POWER” button.

-Verify 12V power is correctly supplied to Video Controller.

-Verify that monitor cable is connected to Video Controller.

-Verify that 12V circuit is on (i.e., ignition position).

•No Video: (Blue screen)

-Make sure all video cables are connected correctly.

-Make sure Source (DVD player, etc…) is “ON.”

-Make sure Source (DVD player, etc…) is in “PLAY” mode.

-Press TV/AV button to ensure correct Input is selected.

6 7