VocoPro Club-8000 quick start Setting up the speakers and speaker stands, Connecting Power

Setting up the speakers and speaker stands

1.Setup each SS-88 speaker stand by extending the support legs to a position that is stable and tighten the tension mecha- nism firmly.

2.Place a VX-15 speaker on top of the SS-88 so that the shaft of the SS-88 fits flush into the mounting cavity on the bottom of the VX-15.

NOTE: Each end of the SS-88 pole has a particular diameter fitted for common speakers’ mounting cavities. If the SS-88 shaft does NOT fit flush into the mounting cavity on the VX-15, loosen the SS-88 pole and reverse it in the stand and then remount the speaker.

3. Repeat the above steps for each speaker and stand.

Connecting Power

VX-15 Speaker

1 1/4”

1 3/4”

SS-88 Stand

Be sure that each product has a power cord firmly attached. It is recommended that you use a power strip/surge protector when connecting your CLUB-8000 to a power outlet.

Connecting the components

Once you have mounted all of the components into the CLUB-8, it is time to connect them. Follow these directions on con- necting the components.

NOTE: If you are also connecting components that are not part of the CLUB-8000 system, please refer to the manual of that product for setup instructions.

MAKE SURE ALL PRODUCTS ARE POWERED OFF

PRIOR TO CONNECTING TO AN AC OUTLET

1 CDG-9000 PRO remote unit to the player unit

Connect the Control Interface Connector from “CONNECT TO MAIN UNIT” jack on the rear panel of the remote unit to the “CONNECT TO REMOTE CONTROLLER” jack on the rear panel of the player unit.

CDG-9000 PRO Controller

CDG-9000 PRO Player