
Front Panel Descriptions
Front Panel
2 | 3 | 4 | 6 |
| a |
|
1 | 5 |
|
| b | c | d |
1.POWER - In the upper postion, this switch turns the
2.ECHO - This controls the level of the ECHO effect for only MIC 1, 2 and 3, and not other input sources. MIC 3 is the only input where the ECHO can be bypassed entirely, so if you donʼt want an equal amount of the effect applied to MIC 1 and 2 (also 3 while that input has its ECHO set ON), turn the ECHO control hard left. ECHO output is then at zero.
3.REPEAT - This sets the number of ECHO repeats before MIC ECHO decays for MIC 1, 2 and 3.
4.DELAY - This control sets the DELAY time in between ECHO repetitions.
5.MIC 1, 2, and 3 LEVEL - These knobs adjust the individual MIC levels.
6.LCD DISPLAY - This display window indicates:
a.Which effect is being applied to source; ECHO, PAN, TRANS, FILTER, FLANGER, REVERB, PITCH or HARMONY
b.BEATS PER MINUTE (BPM). When an external music source is input to the
c.X PARAMETER. The RANGE of each effect is shown here in either a percentage or in miliseconds.
d.Y PARAMETER. The LEVEL of each effect is shown here in a percentage from 0 to 100%.
6