
Rear Panel Descriptions
Rear Panel
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 |
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
1.BALANCED OUTPUT - Connect your Left and Right XLR cables from the
2.TRIM OUTPUT - The output level from the
3.AUDIO OUT - Connect your Left and Right RCA cables from these
4.AUDIO IN - You can connect up to 3 music sources for input selection here, including stereos, disc players, mixers, etc.
5.MIC INSERT - This jack is used for connection of an outboard processor such as a compressor using only a single 1/4” TRS (Tip = send, ring = return, Sleeve = signal ground).
6.ECHO ON/OFF - MIC 3 is the only MIC input which allows you the ability to bypass the ECHO effect entirely rather than simply turning the ECHO level all the way to zero. Press this button in to turn the effect OFF. In the extended postion, the effect is ON.
7.MIC 1, 2 and 3 INPUTS - These jacks accept either 1/4” microphone cables in the center of the input, or line up the 3 prongs of an XLR cable with the XLR connection around the center.
8.FOOTSWITCH - Connect any standard footswitch via 1/4” cable here for remote control of the
9.AC 10V ADAPTOR JACK - Connect included power adaptor here.
9