Getting Started
Filling Water Tank
Before initial use, you must soak the Mineral Cartridge in water for 24 hours. You may use a separate container or Water Tank to do so. If Tank is used, empty water and refill with fresh water prior to use.
Note: the unit may take several minutes to create mist with the initial use of a new Mineral Cartridge.
This Humidifier has a 1 gallon capacity and 2 gallon output in 24 hours (if set to High Output, Continuous Humidity setting).
To fill Water Tank:
1.Unplug Humidifier. Place on firm and level surface, such as the floor.
Note: Spills can occur during cleaning, moving, or refilling Water Tank, so be careful to avoid spills when doing these activities. Do not touch the water inside the Base, as the water temperature can reach 92 degrees F.
2.Remove Water Tank by grasping recessed handle on back (A). Pull outward and lift.
3.Turn Water Tank upside down.
4.Remove Cap (B). Empty any remaining water inside Water Tank. Rinse, wipe clean and dry with clean cloth or paper towel.
5.Place Water Tank in sink with opening at the top.
6.Fill Water Tank with cool tap water (C).
7.Ensure Gasket is properly positioned and secure Cap.
8.Lower Water Tank into Base, positioning Fill Port over raised bump in Base. Once in nested position, the water outlet valve inside Cap will open, releasing water into Base.
A
BC
Note: The rate of water dispensing from Water Tank into Base is controlled by the Mineral Cartridge. The unit may take several minutes to fill the Base.
8English
