VTech CS6114 user manual Telephone base installation, Wall mounting

Getting started

Telephone base installation

Install the telephone base as shown below.

Make sure that the electrical outlet is not controlled by a wall switch.

If you subscribe to digital subscriber line (DSL) high-speed Internet service through your telephone line, you must install a DSL filter between the telephone line cord and telephone wall jack. The filter prevents noise and caller ID problems caused by DSL interference. Contact your DSL service provider for more information about DSL filters.

Telephone wall jack

DSL filter (not included) is

required if you have DSL high-speed Internet service

Telephone line cord

Electrical outlet (not controlled by a wall switch)

Telephone base power adapter

Telephone base

• Use only the power adapter supplied with this product. To order a replacement, visit our website at www.vtechphones.com or call

1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call

1 (800) 267-7377.

•The power adapter is intended to be correctly oriented in a vertical or floor mount position. The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the-table or cabinet outlet.

Wall mounting

Your telephone comes ready for tabletop use. If you prefer to mount your telephone on the wall (optional), it is designed to mount on a standard telephone wall plate.

You can mount the telephone base on the wall by positioning the

top hole at the back of the telephone
base against the top mounting
stud [A]. Then slide the telephone	[A]
base down on the mounting
studs [A] and [B] until it locks
into place.
Mounting
studs
	[B]
	Telephone base