10

Access the answering system remotely

Dial your telephone number from any touc h-tone telephone.
When the system plays the announcemen t, enter the two-digit remote code.
The preset code is 19.
Enter one of the following remote command s.
Command Description
1Play all messages.
2Play only new messages.
3Delete the current message (during playback).
33 Delete all old messages.
4Repeat the current message (during playback).
5Stop.
*5 Hear a list of remote commands.
6Skip to the next message (during playback).
*7 Record a new announcement.
8End the call.
0Turn the answering system on or off.
4. Hang up or press 8 to end the call.
Add and register a handset
The handsets provided with your telephone system are already registered. Each
handset is assigned a number that show on the handset display. Additional
handsets registered to the telephone system are assigned in the sequential order.
This telephone system accommodates up to ve handsets.
You can add new handsets (CS6509/CS6509-14/CS6509-15/CS6509-16,
purchased separately) to your telephone system. Each handset must be registered
with the telephone base before use. When rst purchased, each expansion handset
displays To register HS and See manual alternately. You may need to charge the
handset before registering it to the telephone base.

To register a handset:

Place the new (non-registered) handset i n the telephone base.
2. After about 10 seconds, the handset displays Registering... When the
registration process completes, the handset displays Registered and you
hear a beep. The registration process takes about 90 seconds to complete.
Replace a handset
If you want to replace a handset or reassign the designated handset number of
a registered handset, you must deregister all the handsets and then individually
register each handset.

To deregister all handsets:

Press and hold FIND HANDSET on the telephone base for about 10 seconds
until the IN USE light on the telephone base turns on and starts to ash.
Immediately press FIND HANDSET again. You must press FIND HANDSET
while the IN USE light is still ashing. The IN USE light ashes for approximately
ve seconds.
All handsets display To register HS and S ee manual alternately when the
deregistration process co mpletes. The deregistration process ta kes about
10 seconds to complete.
Troubleshooting
If you have difculty with your telep hone, please try the suggestions bel ow.
For customer service, visit our website at w ww.vtechcanada.com or call
1 (800) 267-7377.
1.
2.
3.
1.
1.
2.
3.
Do not place the handset
in the charger.