Getting started
Battery charging
Once you have installed the battery, the screen indicates the battery status (see the table below). If necessary, place the handset in the telephone base or charger to charge the battery. For best performance, keep the handset in the telephone base or charger when not in use. The battery is fully charged after 16 hours of continuous charging. See the table on page 9 for battery operating times.
If the screen is blank or shows Place in charger, you need to charge the handset without interruption for at least 30 minutes to give the handset enough charge to use the telephone for a short time. When the battery is low, the handset shows Low battery and a flashing 
icon. If you are on a call in low battery mode, the handset plays short beeps to alert you.
The following table summarizes the battery charge indicators and actions to take.
Battery indicators | Battery status | Action | ||||
|
|
|
|
|
|
|
The screen is blank | Battery has very little or | Charge without interruption (at | ||||
or shows Place in | no charge. The handset | least 30 minutes). | ||||
charger and |
| flashes. | cannot be used. |
| ||
|
|
|
|
|
|
|
The screen shows | Battery has enough | Charge without interruption | ||||
Low battery and | charge to be used for a | (about 30 minutes). | ||||
|
| flashes. | short time. |
| ||
|
|
|
|
|
|
|
The screen shows | Battery is charged. | To keep the battery charged, | ||||
HANDSET X. |
| place it in the telephone base | ||||
|
|
|
|
|
| or charger when not in use. |
If you do not plug in the battery into the handset and place it in the telephone base or charger, the screen displays No battery.
