VTech VT-2931 important safety instructions Started

STARTED

SETTING UP YOUR VT 2931

5. Set the TONE/PULSE switch, located on the antenna side of the Base Unit, to the desired dialing mode. In most areas, TONE

is the desired mode.

L1 RINGER LEVEL L2	DIAL MODE
OFF LOWHIGH OFF LLOW2	HIGH PULSE TONE

BASE RINGER TONE/PULSE SWITCH

SWITCHES

GETTING

TELEPHONE

WALL JACK

RJ-14

- +

DC IN 9V	L1/L1+L2	LINEL2
LINE 2		DC

6.After charging the battery pack, connect the telephone line(s).

I.If you have 2 lines coming out of a single wall jack:

Connect a 4-wire (RJ-14) phone cord be- tween the wall jack and the phone jack la- beled L1 / L1+L2 .

RJ-14

TELEPHONE

WALL JACK

WALL

TELEPHONE

WALL JACK

RJ-11 RJ-11

- +

DC IN 9V	L1/L1+L2	LINEL2
LINE 2			DC

If you are wall mounting your Base Unit, a short, 4-wire phone cord is provided for your convenience.

II. If you have 2 lines, each coming out of a separate wall jack:

Connect a phone cord from the wall jack you wish to designate as your LINE1, to the L1 / L1+L2 jack on the back of the phone; next, connect a phone cord from the remaining wall jack to the L2 jack on the phone.

NOTE: You can use your VT 2931 as a one- line phone, as well. For best results, raise the antenna on the Handset and Base Unit when using your telephone.

8