VXI B200 manual For phones without headset ports, Plug other end of the patch cord into port

Handset active indicator light

BLUEPARROTT B200

Controls & Components

Pairing button

Multifunction button / Indicator lights

Volume increase / Microphone mute Volume decrease

Headset active indicator light

Standby/Pairing indicator lights

Installation A

For phones without headset ports

USE T-CORD

Installation B

For phones with headset ports (Cisco phones see Installation C)

USE T-CORD

Installation C

For Cisco models 7940 or higher

with a headset port

USE PATCH CORD

BASIC OPERATION

Charge headset in base for 4 hours before first use. The multifunction button on the headset will turn green when fully charged. After use, this light will turn red. It is not necessary for the light to turn green to use the headset.

Microphone Adjustment: To ensure proper microphone performance, do the following.

1.	The microphone has
	the word TALK or a dot
	printed or embossed
	on it (under the
	cushion). This mark
	must face your mouth.
2.	For quality sound and effective
	background noise cancellation, position

Microphone volume adjustment (located under base)

Patch cord

T-cord

The headset battery charges continuously while the headset is in the base.

AC adapter

1.Remove handset cord from phone’s base.

2.Plug short end of T-cord into now empty handset port on phone.

3.Plug longer end of T-cord into port on B200 base marked “Phone” . Thread cord under hook.

4.Plug handset cord into port on T-cord.

5.Plug ACadapter into port on B200 base

1.Leave handset plugged into your phone.

2.Plug short end of T-cord into headset port on phone.

3.Plug longer end of T-cord into port on B200 base marked “Phone” . Thread cord under hook.

4.Plug ACadapter into port on B200 base

marked and then plug AC adapter into the wall electrical outlet.

1.Leave handset plugged into your phone.

2.Plug the blue-banded end of the patch cord into the headset port on your phone.

3.Plug other end of the patch cord into port

on the B200 base marked “Phone” . Thread cord under hook.

4.Plug ACadapter into port on B200 base

marked and then plug AC adapter into the wall electrical outlet.

microphone a finger’s width away from

your face just below your bottom lip.

The microphone is sensitive, minor

adjustments may be needed to achieve

optimum voice quality.

Standby/Talk Time Modes: The headset is in standby mode whenever you see a slow-flashing yellow light on the headset and the handset icon is lit on the front of the base. If the headset icon is lit, then the headset is active and Talk Time is being used (even if you are not on a call).

Cord wraps

marked and then plug AC adapter into the wall electrical outlet.