Wachsmuth & Krogmann TQ 1.0 - page 15

Q-PON CUTTER
15
5. Always change the cutter brush when changing
blades.
Setting Cutter Speed
1. The low speed side of the gearbox engaged
(3a), the dial speed control should always be
set on “A”(3b). This will keep the blade at its
optimum speed of 100 rpm (Figure 3).
Weld Sample Cutting
1. Cut off desired length from weld centerline.
2. Set cutter depth control to desired diameter
(Figure 4).
SECTION V SETUP & OPERATING PROCEDURES (CONT.)
1. Install FHCS through base plate and stand
support into bottom of TQ 1.0 (Figure 1)
2. Attach vacuum source to port on back of
TQ 1.0 if desired.
Saw Blade Installation
1. Slide back the cutting saw blade guard.
2. Remove cutter tensioning bolt and retaining
washer from spindle.
3. Position saw blade for contact rotation over
spindle.
4. Replace retaining washer and tensioning bolt
using supplied hand tools (Figure 2).
Figure 1
Figure 2
Figure 3
Figure 4