ASSEMBLY
8.Figure 3: Install the pedal stopper (item 1), the bent portion facing the snowblower and secure in place with two 1/4"NC x 5/8" hex. bolts (item 2) and two 1/4"NC serrated flange nuts (item 3). Tighten firmly.
9.Figure 3: Attach the closed end of the tension spring (item 4) to the lifting triangle (item 5). Then, attach the open en of the tension spring (item 4) to the hole in the pedal (item 6).
10.Put the snowblower back in its original position.
11.Figure 4: Install a 8mm x 7mm x 25mm key (item 1) on the gearbox shaft (item 7).
12.Figure 4: Slide the male driveline (item 2) on the gearbox shaft (item 7). The gearbox shaft (item 7) must be covered by the front part of the male driveline.
13.Figure 4: Put thread sealant on the 5/16"NC X 3/8" Allen socket setscrew (item 6) and secure the driveline yoke
(item 2).
14.Figure 4: Secure the driveline yoke (item
2)to the gearbox shaft (item 7) with a 3/8"NC x 1 3/4" (item 3) hex. bolt, a 3/8" lockwasher (item 5) and a 3/8"NC nylon insert nut (item 4). Tighten firmly.
15.Figure 4: Install the two grease fittings (item 8) on both mounting tubes (item 9).
Figure 3
Figure 4
OM | 11 |
