ASSEMBLY
Snowblower Installation on the Tractor
1.Remove the mower deck from the tractor if necessary. Refer to the appropriate Tractor Owner’s Manuel.
2.Figure 8: Attach each lift chain (item 5) to the lift bracket (item 1) with a 5/16" NC x 1 1/4" bolt (item 6) and a 5/16" NC nylon insert locknut (item 7).
3.Figure 8: Attach each lift bracket (item 1) to the predrilled holes (item 2) on the front chassis cross bar with a 5/16"NC x 1" bolt (item 3) and a 5/16"NC serrated flange nut (item 4).
NOTE: Predrilled holes exist only on Walker tractors built after 1984. For earlier models, drill two 5/16" (8mm) holes in the front chassis cross bar at the positions indicated.
IMPORTANT: For all 1980 to 1984 tractors, remove the battery before drilling the right hand hole. Reinstall the battery after the lift brackets have been installed. Refer to the appropriate Tractor Owner’s Manual for battery removal and installation procedures.
4.Figure 9: Place the male half driveline (item 1) of the snowblower PTO shaft into the socket of the female PTO with quick coupler (item 2) and rotate the PTO shaft until it is aligned correctly with the socket in the female PTO with quick coupler, then slide together.
Figure 9
Figure 8
OM | 13 |
