Waring 7155-21 Functional Description Assembly, Removing and Installing the Belt Hook, No-Mar Pad

FUNCTIONAL DESCRIPTION

ASSEMBLY

6

WARNING

Removing and Installing the Belt Hook

4

5 7

8

Disconnect the air supply from the tool and remove fastener strips before changing or removing acces- sories. Only use accessories spe- cifically recommended for this tool by the manufacturer. Others may be hazardous.

The operator and other people in the work area must wear eye protection in accordance with ANSI Z87.1. Eye protection does not fit all operators

Fig. 1

Front of tool

End cap

Belt hook Screw (2)

Air inlet

3

2

1

9

14 13

1512

1. No-mar pad 11 10

2.Workpiece contact

3.Fastener guide

4.Actuation selector

5.Trigger

6.Belt hook

7.Exhaust deflector

8.Air inlet

9.Pusher release button

10.Pusher assembly

11.Magazine

12.Extra no-mar pad storage (on back of magazine)

13.Nameplate (not shown)

14.Warning label (on back of magazine)

15.Depth of drive adjustment

in the same way. Make sure the eye protection chosen has side shields or provides protection from flying debris both from the front and sides.

No-Mar Pad

The No-Mar Pad on the nose of the tool protects the workpiece when the workpiece contact is compressed during actuation. The pad can be removed and replaced.

1.Before removing or replacing no-mar pads, disconnect the air supply from the tool and remove fastener strips.

2.To remove the pad, pull the pad off of the workpiece contact.

3.Storage for an additional pad is available on the magazine of the tool.

4.To replace the pad, fit it into place over the workpiece contact.

Exhaust

The exhaust cap can be adjusted to direct the exhaust as desired. Turn the exhaust cap to the desired locking position.

To remove the hook:

1.Rotate the hook until it snaps into one of the preset positions.

2.Remove the two mounting screws using the wrench provided.

3.Pull the hook off the rear of the tool. To install the hook:

1.Align the spring-loaded post on the hook with a slot on the rear of the tool.

2.Slide the hook onto the tool, making sure the hook points toward the front of the tool. Push the hook up against the end cap.

3.Install the two mounting screws using the wrench provided. Tighten securely.

4.Verify that the hook is installed correctly by firmly pulling the hook toward the air inlet. It must not move.

6 7