Chapter 5
Setup & Configuration
In order to configure Wasp WLR8900/8905 Scanners, you must familiarize yourself with the setup procedures on the following pages. The default settings of the Wasp WLR8900/8905 Scanners are identified on each page and clearly marked using an asterisk (*). The default settings have been preprogrammed for the most common barcode configurations. Use the Setup & Configuration only to customize the Wasp WLR8900/8905 Scanners settings. If you need to configure the scanner, the default settings will be overwritten. All the programmed settings are stored permanently in
In order to configure Wasp WLR8900 Series Scanners, two basic steps need to be followed:
(1)Locate the group that contains the options to be changed.
(2)Scan the barcode representing the option to be changed. The scanner will sound two beeps.
To change Minimum/Maximum Length:
(1)Scan the Minimum or Maximum Length barcode.
(2)Scan a 2 digit value from the ASCII table on pages
(3)Scan the Minimum or Maximum Length barcode again.
Example: To have a minimum length barcode of 1, you must scan a
0 then 1, then scan the minimum barcode again. To have a maximum length barcode of 10, you must scan a 1 then 0, then scan the maximum barcode again.
6
