Wasp Bar Code WWS500

Chapter 4

FACTORY DEFAULT & KEYBOARD CONNECTION

Use the Factory Default barcode to reset the scanner to the Default settings.

Factory Default

Autosense Flash Mode Enable

Scan this Autosense Stand Mode bar code to enable the hands-free autosense

feature of the WWS500 Freedom Scanner. If you desire to turn this mode “off,”

please scan the default bar code above.

Autosense Stand Mode

Factory Default

Note: Enabling this option will significantly increase the WWS500

Freedom Scanners battery consumption.

Contents

Main Table of Contents Chapter 1 Introduction Chapter 2 Barcode Symbologies Chapter 3 Quick Start 1. Unpack 2. Charging the WWS500 3. Setting up the Bluetooth Adaptor If you already have Bluetooth setup on your PC or device, please continue to the next step. Chapter 3 Setup & Configuration In order to configure Wasp WWS500 Freedom Scanner, two basic steps need to be followed: To change Minimum/Maximum Length: Page BEEP AND DELAY Beep Settings BEEP AND DELAY Interblock Delay Intercharacter Delay UPPER/LOWER CASE KEYBOARD LANGUAGE PREAMBLE/POSTAMBLE CONFIGURATION TERMINATOR/CODE ID Terminator Code ID ENABLE/DISABLE BARCODE SYMBOLOGIES Enable Disable ENABLE/DISABLE BARCODE SYMBOLOGIES Enable Disable CODE 39 SETTINGS INTERLEAVED 2 OF 5 AND CODE 93 SETTINGS CODE 128 AND UCC/EAN 128 SETTINGS To Define UCC/EAN 128 Group Separator: Note: MSI PLESSEY SETTINGS CODABAR SETTINGS UPC-A SETTINGS UPC-A SUPPLEMENT SETTINGS / UPC-A TO EAN-13 This option expands the UPC-A barcode to EAN-13. UPC-E SETTINGS UPC-E SUPPLEMENT SETTINGS EAN-8 SETTINGS EAN-8 SUPPLEMENT SETTINGS EAN-13 SETTINGS EAN-13 SUPPLEMENT SETTINGS Chapter 5 BLUETOOTH SETTINGS Bluetooth Power Off Settings Connect and Disconnect Page Page Page Page Page Page Page Appendix C Appendix D Warranty Information FAQ Product Support