11
Table 3 - Programming Parameters
Parameter
Name Description Range of
Values Mi nimum
Increments Default Units of
Measure Notes
P6 Refill
controller 1 to 99 1 33 Enter the value molded into
the end of the refill controller.
P7 Brine draw
value 1 to 99 1 25 Select number from Table 4
and enter that number.
P8 Not used NA NA NA NA NA
P9 Backwash
time 3 to 30 1 14 Minutes Skip this parameter to accept
the default or enter a value.
P10 Slow rinse
time 8 to 125 1 40 Minutes Skip this parameter to accept
the default or enter a value.
P11 Fast rinse
time 2 to 19 1 4 Minutes Skip this parameter to accept
the default or enter a value.
P12 Units of
Mmeasure 0 to 1 1 0 0 = U.S., 1 = Metric. Skip this
parameter to accept U.S. or
enter 1 for Metric.
P13 Clock m ode 0 to 1 1 0
0 = 12-hour clock.
1 = 24-hour clock. Skip this
parameter for a 12-hour clock
or enter 1 for a 24-hour clock.
P14 Calendar
override 0 to 30 1 0 Days 0 = no calendar override. Skip
this parameter for no calendar
override or enter a value.
P15 Reserve type 0 to 3 1 0
0 = variable reserve, 1 = fixed
reserve, 2 = variable reserve
with immediate regen,
3 = fixed reserve with
immediate regen. Skip this
parameter to accept the
default or enter a different
reserve type.
P16
Fixed reserve
capacity or
initial average
value
0 to 70 1 30 Percent of
capacity
Description depends on the
value entered for P15. Skip
this parameter to accept the
default or enter a different
value.
P17 Operation
type 0 to 1 1 0 0 = 5-cycle counter or co-
current conditioner, 1 =
reserved for future use.
P18 Salt/capacity
change
Lockout 0 to 1 1 0
0 = none, 1 = salt/capacity
change locked out. Skip this
parameter to accept the
default or enter 1 to lock out
salt/capacity change.
P19 Factory
defaults 0 to 3 1 9
Loads in a set of default
values. Refer to the Special
Notes for Level II
Parameters section in this
manual.