How to Install the Series
980/985
Figures
6,7
and 8 provide the Series
980/985’s
panel cutout and dimensions.
Do not, however, make your panel cutout until you are sure that you are
placing the control in the best location. Read the noise guidelines at the
beginning of this chapter before installing and wiring the Series
980/985.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Place
the panel cutout in the desired location.
Figure
6 shows you the
panel cutout dimensions.
To install,
carefully
insert the Series
980/985
into the panel cutout.
Push
1
NOTE:
the unit in until the bezel is seated securely against the panel.
Removing the
Series
980/985 chassis
Included with your control are two adjustable mounting brackets; one for the
top and one for the bottom of the control case.
Installing the mounting
from its case may
make mounting
brackets requires access to the back side of the panel.
On the top and bottom of the case are a series of slots running the length of
the case.
The first two shorter slots are for attaching the mounting brack-
ets. Figure 8 shows a side view with both mounting brackets.
easier.
Loosen the mounting bracket screws with a Phillips screwdriver far enough
to allow for the panel thickness.
Make sure that each bracket is placed in the first two slots from the front of
the control, with the head of the screw facing the back of the control.
Refer
to
Figure
8 for screw and bracket placement.
To attach, place the bracket into the slots (head of the screw facing the
back of the
control
and push backward, securing the brackets to the control
case.
Do the same for the other side of the control.
Make sure the Series
980/985
case is seated properly. Tighten the
installa-
tion screws firmly against the panel to secure the unit in place.
To remove the unit from its enclosure, loosen the captive screw at the
bottom of the
980/985’s
front panel with a Phillips screwdriver.
Pull the unit
from its case.
To release the mounting brackets, push the brackets forward and pull out to
release them from the control case.
Install and Wire, Chapter
2
WATLOW
Series
980/985
User’s Manual
11