Chapter

4
1
NOTE:
While in the Setup
menu, all outputs
are OFF.
Figure 27
-
Entering the Setup
Menu.
Figure 28
-
The Setup Menu.
an
NOTE:
When using a
process input such
as
O-5VDC
or
4-2OmA,
the
rL
and
rH
settings scale the
display to match the
measured range of
the process signal.

How To Setup The Series 9801985

Setting up the Series
980/985
is a simple process. First configure the
980/
985’s
features to your application in the Setup Menu, and then enter values in
the
Operating
Menu.
Both
tasks use the MODE key to move through the
menus and the UP/DOWN keys to select data.

Entering the Setup Menu

The Setup Menu displays the parameters that configure the Series
980/985’s
features to your application.
To enter the Setup Menu, press the UP and DOWN keys simultaneously for 3
seconds. See Figure
27.
The Lower display shows the LOC parameter, and
the Upper display shows its current level. All keys are inactive until you release
both keys. You can get to the LOC parameter from anywhere.
Use the MODE key to cycle through the menu; use the UP/DOWN keys to
select Setup data. You may not see all the parameters in this menu, depend-
ing on the unit’s configuration and model number. After stepping through the
menu, you will return to the control set point parameter
under the Operation
menu.
-l
@
Mode Key
Prompt appears or not according
to control configuration.
1
t
Control Set Point
24 WATLOW Series
980/985
User’s Manual Setup, Chapter 4