Series
980/985
Keys
Figure 27
-
Series
980/985
Keys
UP/DOWN keys
MODE Key
When pressed simultaneously for 3
sec-
Steps the control through the
onds, the Setup Menu appears displaying Operating menu; also, in the
the LOC parameter. From the LOC
pa-
Auto mode, enters new data
rameter, press the UP/DOWN keys again
selected less than
5
seconds
and the Calibration Menu appears. previously
.
elIncreases the value
of the displayed
parameter. A light
touch increases the
value by one.
Holding the key
down increases the
display value at a
rapid rate. New
data is self entering
in
5
seconds.
DOWN Key
/
Decreases the value of the
displayed parameter. A light
touch decreases the value by
one. Holding the key down
decreases the displayed value
at a rapid rate. New data is
self entering in
5
seconds.
Where
To Go From -Here
AUTO/MAN Key
Pressed once, it clears any
latched alarms. If the key is
pressed again within
5
seconds, the control toggles
between the Auto and Manual
mode. While in the Manual
mode, percent power is
always displayed in the lower
display.
Auto/Manual LED
Lit
when the control is in Manual opera-
tion. Press the key twice to enter Auto
operation. A blinking Auto/Manual LED
indicates that pressing the Auto/Manual
key toggles between Auto and Manual.
After 5 seconds without pressing the
Auto/Manual key, the
LED stops
blinking,
and returns to its previous state.
Now that you know how to read the keys and displays, continue to Chapter 4 to
begin entering data and setting up your Series
980/985.
Keys and Displays,
Chapter
3
WATLOW Series
980/985
User’s
Manual
23