4. Troubleshooting
Please verify the following points before trying to use the Waves
software on the APA32 unit:
1. The power cable is properly connected.
2. The mains power switch (at the back) is switched on.
3. Network connections:
a. A crossed network cable is connected between the
APA32 and the host computer – in the case of connecting
a single APA32 directly to the host computer.
b. A standard network cable is connected between the
APA32 and an Ethernet switch. The switch is connected
with a standard network cable to the host computer – in
the case of connecting several APA32 units to the host
computer.
4. The APA32 is switched on (by pressing the power button at the
front) and the power LED is illuminating.
In case it is necessary to restart the APA32 unit, this can be done in
two ways:
1. Press and hold the power button for a few seconds to switch the
unit off, and then press it again to switch the unit on.
2. Insert a small pin into the Reset socket on the unit’s front panel
and press the reset button to restart the unit.
7