Waves Doubler manual The Direct signal controls, EQ Controls

MODULATION DEPTH: –200 to +200 in cents. Default: 0.

Positive values will start by modulating upwards, negative values will start off modulating downwards. The modulation will always occur around the voice’s nominal detune so if you set a detune of 10 and a Mod Depth of 10, the voice will begin by going upward 10 cents and then downward 20 cents, reaching 10 cents below the nominal detune.

MODULATION RATE: 0.1 to 200Hz. Default: 1Hz.

This value sets the voice’s pitch modulation rate. At 1Hz the modulation will complete a full cycle in 1 second.

The Direct signal controls

ON/OFF: Default: On.

Turns the voice on or off.

GAIN: 0 to –48dBfs. Default: –12.

Sets the gain of the voice in relation to the other voices. The master gain can further change the actual output gain of all voices.

PAN: –45 to +45 degrees. Default: V1 22.5, V2 –22.5, V3 45, V4 –45. +45deg is fully right. –45deg is fully left. 0 is in the middle. In Stereo sources the Pan for the direct will actually behave as a Rotation control for the whole stereo image.

EQ Controls

The Doublers EQ section offers a Hi Shelf and Low Shelf filter. These filters will affect the Doubler’s voices, but not the direct signal. The controls for the filter are as follows:

ON/OFF: Default: On.

These turn the filter on and off allowing a quick A/B comparison to an EQ setting in relation to no EQ. Double clicking on the Graph markers will also turn the filter on and off.

GAIN: +12dB to –24dB

The Shelf can boost all that beyond its corner frequency by up to 12dB. It can cut down much lower than that, down to -24dB, at which point the filter floor drops to make a cut filter.

Waves Doubler software guide page 4 of 6