Wayne 353601-001 Battery Information, PS/BC Features, CHART 1 - STANDBY POWER, Pumping Capacity

Operating Instructions and Parts Manual
Battery Information		If battery acid		CHART 1 - STANDBY POWER
The system is designed to operate most		contacts your		PUMPING CAPACITY
efficiently with sealed lead acid (SLA)	eye(s), flush with cold running water			Amp Hours	Total Gallons
	for 10 minutes and seek immediate
batteries. Deep cycle marine batteries				Per Battery	Pumped*
	medical attention. If acid contacts your
can also be used.				40.0	11,000
	skin or clothing, wash immediately
				80.0	22,000
Sealed lead acid batteries cost slightly	with soap and water.
				120.0	33,000
more, but they can last longer. Wayne		Never smoke or
			* Assumes the sump pump is lifting water 10’
offers a 40 amp hour battery WSB1240
		allow a spark or
and a 75 amp hour battery WSB1275.	flame in the vicinity of the battery.		SYSTEM WILL ALARM IF:
The oversize battery case (included) will		Avoid dropping
			• You will hear a beeping alarm if
accommodate two 12-volt SLA batteries
		metal tools on the		pump motor is running
or two 12-volt deep cycle marine batteries	battery posts because they may spark or
			•	You will hear a continuous alarm if the
(up to a 27-frame size).	short-circuit the system or battery,
				pump fuse on front panel is blown
Retain blue foam pad to support Wayne	causing an explosion.
			• You will hear a continuous alarm if
sealed lead-acid batteries. Use new,
	PS/BC Features			the battery voltage drops below 21.6
identical batteries (from the same
				NOTE: The alarm must be on for the
manufacturer and of the same capacity).	POWER CIRCUITS:			mute function to activate.
When batteries wear out replace them as	• Power Supply/Battery Charger (PS/BC)		LIGHTS:
a set. Chart 1 illustrates the expected	monitors power availability and		•	Green Light indicates AC power is
performance with various battery	automatically switches to battery			available
combinations. Do not use batteries rated	operation during power outage.		•	Yellow Light indicates battery is
below 40 amp hours.	• Charger will run pump motor or charge			connected correctly
Be certain that the area around the	batteries when plugged into AC power		• Red Light is on when battery voltage
batteries is well ventilated. Before	• Automatically charges the batteries			is low or if the pump motor fuse on
servicing the batteries, blow away	• Operates on 120 VAC and 24 VDC			the front panel is blown
gasses by waving a piece of cardboard	(Using 2 batteries)		PUMP:
	• The PS/BC can be left connected to
near the batteries.			• The pump will turn on when the
	the batteries indefinitely
Dangerous				float switch rises. The pump motor
	• The PS/BC is designed for the Wayne
hydrogen gas can				will keep running for 15 seconds
be released from batteries while	Water Systems pump only, DO NOT
				after the float drops
charging. Sparks can ignite the gas in	Use For Any Other Purpose
an enclosed space. Wear safety goggles
when connecting batteries. Battery
connections should be made in a well-
ventilated area.
Working in the
vicinity of lead acid	(Black)
batteries can be dangerous. Before	Negative
making connections or servicing the	Battery Cable				PS/BC
batteries, read and follow instructions in
all applicable instruction manuals. To
reduce the risk of battery explosion,
follow the instructions in this manual
and those published by the battery				(Red)
manufacturer, as well as those of any
other equipment used in the				Positive Battery Cable
surrounding area.
An assistant should be present or close
enough to come to your aid in the
event of an emergency. Have a reliable	B			Jumper Wire
source of fresh water and soap nearby		A
in case battery acid contacts clothing,	12V
		12V
skin or eyes.	Battery
Wear eye and clothing protection when		Battery
working around lead acid batteries.
Avoid touching your eyes when
working around lead acid batteries.	Figure 1 - Battery connection: two 12-volt batteries equals a 24-volt battery
www.waynepumps.com
		2