Optional Installation
Trolley Arm Hookup
NOTE: If
Align hole in the door arm with holes in operator bracket tabs, as shown. Attach with 5/16” x
Drawbar operator | 5/16” x | |
Clevis pin | ||
bracket tabs | ||
Cotter |
| |
ring | Cotter ring | |
5/16” x | Door arm | |
Clevis pin | ||
|
Inside Lock
Install the inside lock on the second section of the door. Secure the lock to the section with
(4)1/4” - 20 x 11/16” self drilling screws. Square the lock assembly with the door section, and align with the square hole in the vertical track. The inside lock should be spaced ap- proximately 1/8” away from the section edge.
Important: Inside lock(s) must be removed or made inoperative in the un- locked position if an operator is installed on this door.
| Square hole in |
| vertical track |
Second section |
|
| (4) |
| Self drilling screws |
Side lock | 1/8” |
| |
End stile |
|
Pull Down Rope
WarningARNING
Do not install pull down rope on doors with operators. Children may become entangled in the rope causing severe or fatal injury.
Measure and mark the jamb approximately 48” to 50” (1220 to 1270 mm) from floor on the right or left side of jamb. Drill 1/8” pilot hole for no. 6 screw eye. Tie the pull down rope to the no. 6 screw eye and to the bottom corner bracket, as shown.
| No. 6 Screw eye | |
| Typical bottom | |
| corner bracket | |
48” to 50” | Pull down | |
From floor | ||
rope | ||
| ||
Pull |
| |
down |
| |
rope |
|
21