Optional Installation
Inside Lock
Tools: Power drill, 7/16” Socket driver, Tape measure
Install the inside lock on the second section of the door. Secure the lock to the section with (4)
Important: Inside lock(s) must be removed or made inoperative in the unlocked position if an operator is installed on this door.
| Square hole in |
| vertical track |
Second section |
|
| (4) |
| Self drilling screws |
Side lock | 1/8” |
| |
End stile |
|
Pull Down Rope
Tools: Power drill, 1/8” Drill bit, Tape measure
WARNING
Do not install pull down rope on doors with operators. Children may become entangled in the rope causing severe or fatal injury.
Measure and mark the jamb approximately 48” to 50” (1220 to 1270 mm) from floor on the right or left side of jamb. Drill 1/8” pilot hole for no. 6 screw eye. Tie the pull down rope to the no. 6 screw eye and to the bottom corner bracket, as shown.
| No. 6 Screw eye | |
| Typical bottom | |
| corner bracket | |
48” to 50” | Pull down | |
From floor | ||
rope | ||
| ||
Pull |
| |
down |
| |
rope |
|
Door Arm Hookup
Tools: Needle nose pliers
NOTE: If overhead door operator/ trolley bracket was installed, follow these directions.
Align hole in the door arm with holes in drawbar operator bracket tabs, as shown. Attach with 5/16” x
Drawbar operator | 5/16” x | |
Clevis pin | ||
bracket tabs | ||
Cotter |
| |
ring | Cotter ring | |
5/16” x | Typical trolley arm | |
Clevis pin | ||
|
15
Please Do Not Return This Product To The Store. Contact your local
refer to your local yellow pages business listings or go to the Find a Dealer section online at