1/3 HP Sink Pump
System
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for future reference.
Operating Instructions & Parts Manual | SYLT30 |
|
|
Description
This system pumps water up to an existing water drain and is designed for residential use in laundry trays, washing machines, wet bar sinks, sinks and tubs, dehumidifiers, and air conditioners. The submersible sump pump included in this system is equipped with an
Unpacking
Inspect this unit before it is used. Occasionally, products are damaged during shipment. If the pump or components are damaged, call our customer service department at
Safety Guidelines
This manual contains information that is very important to know and understand. This information is provided for SAFETY and to PREVENT EQUIPMENT PROBLEMS. To help recognize this information, observe the following symbols.
Danger indicates an imminently
hazardous situation which, if not avoided, WILL result in death or serious injury.
Warning indicates a potentially
hazardous situation which, if not avoided, COULD result in death or serious injury.
Caution indicates a potentially
hazardous situation which, if not avoided, MAY result in minor or moderate injury.
Notice indicates important
information, that if not followed, MAY cause damage to equipment.
General Safety
Information
CALIFORNIA PROPOSITION 65
This product or
its power cord may
contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm.
Wash hands after handling.
GENERAL SAFETY INFORMATION
1.Know the pump application, limitations, and potential hazards.
Do NOT use to
pump flammable or explosive fluids such as gasoline, fuel oil, kerosene, etc. Do NOT use in
flammable and/or explosive atmospheres. Use pump only with liquids compatible with pump component materials. Failure to follow this warning can result in personal injury and/or property damage.
Disconnect power
before servicing. If the power disconnect is out of sight, lock in the open position and tag
it to prevent unexpected application of power. Failure to do so could result in fatal electrical shock!
2.Drain all liquids from the system before servicing.
3.Periodically inspect the pump and system components. Perform routine maintenance as required (See maintenance section).
4.When wiring an electrically driven pump such as this, follow all electrical and safety codes, as well as the most recent National Electrical Code (NEC) and the Occupational Safety and Health Act (OSHA).
5.All wiring should be performed by a qualified electrician.
6.It is strongly recommended that this unit is plugged into a Ground Fault Circuit Interrupter (GFCI). Consult a
local electrician for installation and availability.
7.This pump is designed to transfer water in cycles. Using this pump in a continuous duty application by manipulating the switch to stay on, will effect the performance and the life of the product.
8.Protect electrical cord from sharp objects, hot surfaces, oil, and chemicals. Avoid kinking the cord. Replace or repair damaged or worn cords immediately. Use wire of adequate size to minimize voltage drop at the motor.
9.Do not handle a pump or pump motor with wet hands or when standing on a wet or damp surface, or in water.
Do NOT walk on
wet area until all power has been turned off. If the
electric company to
Assembly
Assembly Instructions:
1.Remove packaging, including the foam inside the tank.
2.Apply gasket to top of tank, just outside the opening. (See Figure 1)
Figure 1: Adding Lid Gasket to Tank 
REMINDER: Keep your dated proof of purchase for warranty purposes!
Attach it to this manual or file it for safekeeping.
© 2011, WAYNE Water Systems/Scott Fetzer. | For parts, product & service information | |
| visit www.waynepumps.com |
|
