SYLT30
Operation
Always disconnect
the power source before attempting to install, service, relocate or maintain the pump. NEVER touch the sump pump, pump motor, water or discharge piping when pump is connected to electrical power. NEVER handle a pump or pump motor with wet hands or when standing on wet or damp surface or in water. Fatal electrical shock could occur.
1.It is required that this unit be plugged into a Ground Fault Circuit Interrupter (GFCI) as shown in Figure 5. Consult a local electrician for installation and availability.
Power Cord
GFCI
Outlet |
|
|
|
TEST |
| RESET |
Grounding Blade
Figure 5: Grounding outlet and power cord
Risk of electrical
shock! This pump is supplied with a grounding conductor and grounding type attachment
plug. Use a grounded receptacle to reduce the risk of fatal electrical shock. NEVER cut off the round grounding prong. Cutting the cord or plug will void the warranty and make the pump inoperable.
2.Protect electrical cord from sharp objects, hot surfaces, oil, and chemicals. Avoid kinking the cord. Replace or repair damaged or worn cords immediately. Use wire of adequate size to minimize voltage drop at the motor.
3.Do not handle a pump or pump motor with wet hands or when standing on a wet or damp surface, or in water.
4.This pump is only for use on 120 Volt
5.Insert the pump power cord plug directly into the back of the float switch cord plug (See Figure 6).
6.Test operation of the system by adding water to the inlet. The pump will start automatically when the water has filled the reservoir to a depth of approximately 9 inches. The pump will stop when the water depth is approximately 4 inches. The pump will cycle thereafter as required.
Do NOT operate the pump unless it is
submerged in water. Dry running causes pump failure. The motor is equipped with an automatic reset thermal protector.
Maintenance
Always disconnect
the power source before attempting to install, service, relocate or maintain the pump.
NEVER touch sump pump, pump motor, water or discharge piping when pump is connected to electrical power. NEVER handle a pump or pump motor with wet hands or when standing on wet or damp surface or in water. Fatal electrical shock could occur.
Risk of personal
injury! Wear safety glasses at all times when performing maintenance on this pump
system. Failure to follow this warning could result in death or serious injury.
1.Let the pump cool for a minimum of two hours before servicing because the pump contains hot oil under pressure and the motor is hot.
This pump |
|
contains | O I L |
dielectric motor oil for
lubrication and motor heat transfer. This oil can be
harmful to the environment. Check state environmental laws before disposing of this oil.
2.Disassembly of the motor prior to expiration of warranty will void the warranty. If repairs are required, see troubleshooting chart.
3.Inlet should be kept clean and free of all foreign objects and inspected annually. A clogged inlet will damage the pump.
4.Pump should be checked monthly for proper operation.
GFCI Outlet
Pump Power
Cord
Float Switch
Piggyback Plug
Figure 6: Piggyback Plug and Power Cord
www.waynepumps.com
3